Publicidad
Idiomas disponibles
Idiomas disponibles
After processing
7.6.
• Press the
button on the control panel to stop the current
supply to the marking/etching wand.
• Put the wand back in its holder (A).
At the end of processing, always store the
wand and other accessories appropriately.
If the wand should remain accidentally
powered while resting on the treated piece,
the electrochemical marking process would
continue on each portion of stainless steel in
contact with the pad and would permanently
damage it.
Never place the wand on top of the device
during breaks or at the end of processing,
as the electrolyte solution could drip from the
dampened pad and penetrate inside the unit.
Always use the appropriate holder and empty
the collection tray when necessary.
The device should in any case be kept as
clean as possible.
• Disconnect the ground cable crocodile clip from the machined part.
• Use the SURFOX-N solution on the treated piece.
It is very important to spray the SURFOX-N
solution on the workpiece; this product
neutralizes any residual marking solution,
thus avoiding the formation of halos and white
spots.
Alternatively, it is possible to clean the surface
with an abundant jet of water.
• Rub the surface with a microfiber cloth dampened with
clean water.
• Dry the surface using a dry microfiber cloth.
Shutdown
7.7.
• Turn off the device by turning the main switch to the "O" position.
• Disconnect the unit plug from the power supply socket.
• Carry out routine maintenance on the device as described in chapter 8.1.
• To limit any environmental impact, used pad and used liquids must always be disposed of in accordance with current waste
disposal regulations (see chapter 9 for additional information).
30
A
Publicidad
