Walter SURFOX MAX Serie Manual Del Usuario página 27

Marking insert installation
7.2.
When installing the inserts, the marking/etching wand should not be connected to the device.
• Take the marking insert
54-B 088
• Insert the coupling tab (A) into the appropriate slot in the
marking/etching wand.
• Tighten the set screw using a 2.5 mm hex wrench (B).
Mounting a pad on the marking insert
7.3.
When installing the pad, the marking/etching wand must not be connected to the device.
insert on the marking/etching wand (see chapter 7.2).
54-B 088
• Install the
pad into a "U" shape and stick it on to the electrode.
54-B 083
• Fold the
• Fasten the pad in place using the
.
54-B 089
O-ring (A).
B
A
A
27