Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical installation
7.4.
• Connect the ground cable connector (A) to the red socket on the front panel of the unit.
• Use the connecting cable (B) to carry out the electrical installation of the marking/etching wand; connect one end to the
appropriate coupling on the wand (C) and the other into the designated socket on the front panel of the device (D).
B
• Lay the screen-printing stencil (E) on the piece to
be marked/etched and check that all the preliminary
operations described in chapter 5 have been carried out
correctly. In particular, make sure that the ground cable
crocodile clip has been fastened to the stainless steel
piece to be treated.
Before using a new screen-printing stencil, it
is recommended that you use it on a sample
surface to make some test markings in order
to fully open its meshes and obtain an optimal
image.
28
A
C
D
E
Publicidad
