Walter SURFOX MAX Serie Manual Del Usuario página 31

8. MAINTENANCE
Maintenance must be performed on the device only by qualified technicians authorized by the manufacturer.
WALTER is not liable for loss or damage caused to the device during repair operations carried out by personnel not
specifically trained for this task.
The manufacturer also assumes no liability in the case of use of non-original parts or accessories during maintenance work; any
direct or indirect loss or damage caused by such conduct is entirely the liability of the customer.
It is important to always proceed with extreme caution during maintenance operations, remembering to:
• Switch the main switch to the "O" position.
• Disconnect the device from the mains.
• If maintenance operations require the device to be opened, always take the utmost care in handling the internal parts,
especially if it is suspected that there is a loss of electrolyte solution from the hydraulic circuit.
• Be careful when removing components inside the device as the plates and supports may have sharp edges.
It is recommended that you consult chapter 1, where all the safety regulations are detailed so that you can work on the
device while also minimizing risks.
Routine maintenance
8.1.
B
EFORE EACH WORK SHIFT
• Check all components of the device for wear and replace
them if necessary; use only original spare parts.
• Ensure that the sockets, connectors and cables used are
in good condition; the reliability of all electrical equipment
must always be guaranteed.
• Keep the ventilation slots on the unit clean to ensure
that these openings are not obstructed by any obstacles.
Keep enough space around the device to ensure proper
ventilation.
Extraordinary maintenance
8.2.
Extraordinary maintenance operations are usually carried out by specialized technicians of the WALTER company or by its
network of authorized service centers.
C
LEANING PROCEDURES AT THE END OF THE WORK SHIFT
It's important to keep the device as clean as possible.
• Remove the brushes/pads from the adaptor/insert to
prevent the formation of incrustations on the electrode
due to the evaporation of the electrolyte solution.
• Neutralize all these tools with the SURFOX-N solution.
• After neutralizing, always rinse the brushes/pads with
clean water and dry them with a dry microfiber cloth.
• If the brushes/pads show obvious signs of wear or burns,
replace them immediately.
• Once cooled, clean the wand insert and tip with running
water to prevent the formation of incrustations.
• Clean dust and dirt deposits on the outside of the unit.
• Keep air vents clean and free of any obstructions.
• Clean the power cord to prevent deterioration and check
for possible damage to the cord and plug.
31