Sears Kenmore 61021 Manual Del Propietário página 11

Clock and Timer oosom0 mod0,s)
in 402
SET TIME
tO.O @
(appearance may vary)
Follow the directions below if your range has the clock
and timer shown above° You have the choice of having
the timer show the time counting down or the time of
day. In either case, the timer will signal at the end of
the timer period to alert you that tile time is upo
To Set the Clock
NOTE: When you first plug in the range or after a
power failure, the entire Clock/Timer display will
light up.
1° Press the CLOCK pad.
2. Press and hold the UP or DOWN pad and the time
of day wilt change 10 minutes at a time. To change
the time by single minutes, give the pads short taps.
3. Press the CLOCK pad to start the clock.
To Set the Timer
1. Press the TIMER ON/OFF pad.
2. Use the UP and DOWN pads to set the timer
Short taps on the LIP or DOWN pad change the
timers setting one minute at a time. Pressing and
continuing to hold the UP pad increases the setting
ten minutes at a time.
3. Once you have set your timer, press the TIMER
ON/OFF pad to start timing° As the timer counts
down a signal will indicate when one minute is left.
After this signal, the display will count down in
seconds. When
time rims out,
a final signal wi_ sound.
Press the TIMER ON/OFF pad to stop the signal.
To Change or Cancel the Timer Setting
When the timer is counting down, use the UP and
DOWN pads to change the remaining time, or press
the TIMER ONIOFF pad to stop the timer. The timer
cannot be cancelled unless you have fully completed
"set timer" instructions above.
To Display the Clock While
the Timer is Operating
Pressing the CLOCK pad while the timer is operating
will not interfere with the timers operation; the display
will change to show the clock, but the timer will continue
to count down and will still signal when time is up.
Press the TIMER ONtOFF pad again to change the
display back to show the timer.
11