Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
instructions/co0t 0°0d
PREPARATION
• Remove
all tape and packaging.
Lift tip the cooktop
(on models
with standard
twin burners)
and remove
any packing
material
under
it. Make sure the standard
twin burners
are properly
seated and level.
• Remove
plastic
film that covers some chrome
parts
(around
oven door, side trim).
• Take the accessory
pack out of the ovem
• Check
to be sure that no range parts have come loose
during
shipping_
STEP
I
Provide
Adequate
Gas Supply
Your range is designed
to operate
at a pressure
of
4" (10.2 cm) of water column
on natura!
gas or, if
designed
for LP gas (propane
or butane),
10"
(25°4 cm)
of water
column.
Make sure you are supplying
your
range with
the type of gas for which
it is designed°
This range is convertible
for use on natural
or propane
gas. If you decide
to use this range on LP gas,
conversion
must
be made by a qualified
LP installer
before attempting
to operate
the range on that gas°
For proper
operation,
the pressure
of natural
gas
supplied
to the regulator
must
be between
4" (10.2 cm)
and 13" (33 cm) of water
column.
For LP gas, the
pressure
supplied
must
be between
I0"
(25°4 cm)
and
13" (33 cm)
of water column.
When
checking
for
proper
operation
of the regulator,
the inlet pressure
must be at least I" (2°5 cm) greater than
the operating
(manifold)
pressure
as given above. The pressure
regulator
located
at the inlet of the range manif61d
must remain
in the supply
line regardless
of whether
natural
or LP gas is being used. A flexible
metal
appliance
connector
used to connect
the range to the
gas supply
line should
have an I.Do of !/2" and be
5 feet (1,5 m) in length
for ease of installation_
In
Canada,
flexible connectors
must be single wall metal
connectors
no longer than 6 feet (1.8 m) in length.
STEP
2
Connect
the Range to Gas
Shut off the main gas supply valve before
disconnecting
the old range arid leave it off until
new hook-up
has
been completed°
Don't
forget
to relight
the pilot
on
other
gas appliances
when
you turn
the gas back om
Because hard piping
restricts
movement
of the range,
the use of an A.G.A.-certified
flexible
metal appliance
connector
is recommended
unless local codes require
a
hard-piped
connection,
Never
use an old connector
when
installing
a new range.
If the hard piping
method
is used, you must
carefully
align the pipe; the
range cannot
be moved
after the connection
is made.
To prevent
gas leaks, use pipe joint
compound
or
wrap Teflon*
pipe thread
tape around
all male
(external)
pipe threads.
*Teflon: Registered trademark of DuPont
Gas Pipe and Electric
Outlet
Locations
for Hodels
Equipped
with Sealed Burners
This area allows
_3° _ /I
for flush range
installation with
through-the-wall
connection of pipe
stub/shut-off
vaive and rear
wall 120V outlet,
Shortest
connection
from hard pipe
[ stub location to
[range hookup
This area allows for
flush range instatlation
with through-the-floor
connection of pipe
stub/shut-off valve,
32
Publicidad
