CYBEX gold SIRONA G i-Size Guia Del Usuario página 11

PRODUCT PARTS
Newborn inlay (1)
Size indicator (2)
Driving direction control (D.D.C) (3)
Load leg (4)
ISOFIX-Release buttons (5)
ISOFIX-Locking arms (6)
Base (7)
ISOFIX-Anchorage points (8)
ISOFIX-Indicator (9)
Load leg adjustment button (10)
Load leg indicator (11)
Seat locking indicator (12)
THE CORRECT POSITION IN THE VEHICLE
This is an i-Size Enhanced Child Restraint System. It is approved according
to UN Regulation No. R129/03 on Base G, for use in i-Size compatible vehicle
seating positions as indicated by vehicle manufacturers in their vehicle user
manuals. If your vehicle does not have an i-Size seating position, please check
the vehicle Type List. You can obtain the most up-to-date version of the Type
List from go.cybex-online.com/sirona-g-isize-car-compatibility.
It is not guaranteed that all sitting and reclining positions can be used in all
approved vehicles.
Seat release handle (13)
Headrest (14)
Headrest adjustment handle (15)
Seat rotation handle (16)
Driving direction indicator (17)
Position adjustment handle (18)
Belt adjustment button (19)
Shoulder belt (20)
Belt buckle (21)
Buckle tongue (22)
Lap belts (23)
Central adjustment belt (24)
DIFFERENT USES OF THE SEAT
40 – 105 cm,
max. 19 kg
BASE Z2 BASE Z2
BASE Z2 BASE Z2
40 – 60 cm > 60 cm
If you purchased a newborn inlay (1), it should be removed when your child is
taller than 60 cm.
The Size indicator (2) shows the size your child must reach before it is at the
earliest permitted to convert the seat for forward-facing use.
INSTALLATION IN THE VEHICLE
Always ensure that...
• the backrests in the vehicle are locked in their upright position.
• when installing the car seat on the front passenger seat, adjust the vehicle
seat as far back as possible.
�� The car seat is exclusively made for forward facing car seats, which are
equipped with ISOFIX.
Installation of the car seat with Base G
1. Keep the Driving Direction Control (D.D.C.) button (3) in the middle position
and ensure that the base is adjusted for rearward facing car seats.
2. Fold out the Load leg (4) until it locks into its foremost position.
3. Release the ISOFIX-Release buttons (5) to extend the ISOFIX-Locking
arms (6).
The ISOFIX-Release buttons can both be released independently allowing
��
the ISOFIX-Locking arms to be adjusted independently.
76 – 105 cm, > 15 M
max. 19 kg
BASE Z2 BASE Z2
EN
7