Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING
sistance when lifting the generator. Never attempt to
lift the unit by the handle. Hold the unit by the frame
and use proper lifting techniques to reduce the risk of
back injury.
REMOVING CARTON CONTENTS
WARNING
Do not attempt to operate this product if any items in
the INCLUDED LIST are already assembled when
you remove the carton contents. These items are not
assembled by the manufacturer and should require
customer assembly. Using an improperly assembled
product can be hazardous and could result in serious
personal injury.
l Carefully cut down the sides of the packaging and remove
the carton contents.
l Inspect the carton contents. Verify that all the items in the
INCLUDED LIST are present and undamaged.
l Recycle or dispose of the packaging materials properly.
INCLUDED LIST
Generator, wheels, axles, feet, bolts, handle assembly,
engine oil (SAE 10W 30), funnel, parallel cable, spark plug
wrench, user manual and quick start guide.
If any parts are missing, contact our service team at
service@wpowereq.com or call 1-855-944-3571.
INSTALLING THE FEET
See Figure 8.
NOTE: This unit ships without oil. The feet and wheels
should be installed before adding any oil to the engine. Do
not place the generator on its side when there is oil in the
engine.
l Place the generator on its side on a towel or blanket to
prevent damaging the case.
l Locate the feet and bolts.
l Insert the bolt through the hole in the foot and thread into
the hole on the bottom of the generator.
l Tighten bolts securely
l Repeat these steps to install second foot.
INSTALLING THE WHEELS
See Figure 9.
l Place the generator on its side on a towel or blanket to
prevent damaging the case.
l Locate the axles and wheels.
l Insert an axle through the middle of the wheel as shown.
l Thread the axle into the hole on the side of the generator
and tighten securely.
l Repeat these steps to install second wheel.
14 | English
Weight hazard. Always have as-
This product requires assembly.
FIG. 8
A - Foot
B - Bolt
FIG. 9
A - Axle
B - Wheel
C - Handle assembly
D - Handle bolt
INSTALLING THE HANDLE
See Figure 9.
l Place the generator on a flat, level surface.
l Locate the handle assembly and bolts.
l Align the handle assembly with the generator as shown.
l Insert the handle bolt through the hole on the handle
assembly. Tighten securely.
l Repeat these steps to attach the other side.
A
B
D
B
C
A
Publicidad
