Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
l After the engine starts, turn the engine/fuel control switch
to the GASOLINE OFF position.
l Allow the generator to run until the fuel in the carburetor
is depleted and the engine stops.
l Turn the engine/fuel control switch to the OFF position
To drain the fuel tank:
NOTICE
To prevent damage to the unit, drain the
engine oil before emptying the fuel tank. See Chang-
ing the engine oil for details.
l Turn the engine/fuel control switch to the OFF position
l Clean area around fuel cap and remove the cap slowly.
l Remove the fuel screen filter by slightly compressing it
while removing it from the tank.
l Using a commercially available gasoline hand pump (not
included), siphon the gasoline from the fuel tank into an
approved gasoline container. DO NOT use an electric
pump.
NOTE: The fuel tank can also be drained using the carbu-
retor drain screw and drain hose as described earlier. Keep
the engine/fuel control switch in the OFF position to allow
fuel to flow from the tank through the carburetor.
REPLACING THE FUEL FILTER
See Figure 28.
Overtime, the fuel filter may become dirty or clogged. To re-
duce the risk of engine failure, replace the fuel filter accord-
ing to the figures specified in the maintenance schedule
or the engine manual (if applicable).
l Turn the generator off and allow the engine to cool for
30 minutes.
l Drain the fuel tank as described previously.
l Remove the screws securing the control panel.
l Remove the control panel.
l Locate the fuel filter and note the filter's orientation.
l Using pliers, squeeze the fuel line clips and slide the fuel
lines away from the filter.
l Install the fuel lines onto the new filter. Ensure the fuel
filter is oriented correctly.
l Replace the control and tighten screws securely.
28 | English
FIG. 27
FIG. 28
A - Fuel line
B - Fuel filter
CHECKING/ADJUSTING THE VALVE
CLEARANCE
See Figures 29 - 30.
NOTICE
Checking and adjusting valve clear-
ance must be done when the engine is cold.
l Turn the generator off and allow the engine to cool for
30 minutes.
l Place the generator on a level surface in a well-ventilated
area.
l Remove the rocker arm cover and carefully remove the
gasket. If the gasket is torn or damaged, it must be re-
placed.
l Remove the spark plug so the engine can be rotated more
easily.
l Pull the recoil handle to rotate the engine to top dead
center (TDC). Looking through the spark plug hole; the
piston should be at the top (both valves are closed).
l Both rocker arms should be loose at TDC on the com-
pression stroke. If they are not, rotate the engine 360°.
B
A
A
Publicidad
