Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
DATA CENTER
See Figure 17.
Push the mode button to cycle through the data display
modes.
Voltage: Displays current voltage output.
Frequency (Hz): Displays power output frequency in Hertz.
Lifetime Hours: Displays the lifetime run hours.
Fuel Level: Indicates how much gasoline remains in the
fuel tank.
Run Time/Maintenance: Displays current run time. Resets
to zero when shut down. Maintenance reminder displayed
when required.
Maintenance Codes:
P25 – Change engine oil
P50 – Clean air filter, Change engine oil
P100 – Change engine oil, clean air filter, replace fuel filter
SELECTING THE FUEL SOURCE
See Figure 18.
DANGER
NOT add gasoline to the fuel tank or connect the LPG/
propane hose to the generator while the generator is
in operation.
NOTICE
Do not overload the generator. Load
capacities differ depending on the fuel source. Before
switching fuel sources, make sure the generator can
supply enough running (continuous) and peak (start-
ing) watts for the items your connected items.
The fuel source can be switched while the engine is off
or while it is running if a propane tank is connected to the
generator BEFORE operation. If you switch from gasoline
to another fuel source while the engine is running, it may
run rough for a few seconds as it purges gasoline from the
carburetor.
To switch to gasoline:
l Turn the fuel valve to the open position to start the flow
of gasoline.
l Rotate the fuel selector switch fully clockwise for
GASOLINE.
l Turn off the flow of propane gas.
To switch to propane:
l Open the cylinder valve on the LP gas cylinder to start
the flow of propane.
l Rotate the fuel selector switch fully counterclockwise for
PROPANE.
l Turn off the flow of gasoline.
20 | English
Fire and explosion hazard. DO
FIG. 17
A
C
E
A - Voltage
B - Power output
C - Lifetime hours
D - Fuel level
E - Run time/maintenance reminder
F - Mode button
FIG. 18
A
A - Propane
B - Gasoline
C - Fuel selector switch
F
B
D
B
C
Publicidad
