Parkside PKGA 20-Li C2 Traduccion Del Manual De Instrucciones Originale página 39

3.­ If­you­place­the­direction­switch­
(7)­in­the­middle­position,­the­device­is­
secured against being switched on.
The direction change may only be
actuated­when­at­a­standstill!
Torque adjustment
You­can­preselect­the­maximum­torque.­
The­torque­settings­are­labelled­1­-­19­+­
1.­ Wait­for­the­appliance­to­come­to­a­
standstill.
2.­ Turn­the­torque­adjusting­ring­(2)­to­
select the desired torque:
Screws: ­
Drilling:­­
3. Start with a lower torque­step­and­
increase as required.
The direction change may only be
actuated­when­the­appliance­is­at­a­
standstill!
­ The­necessary­torque­is­dependent­on:
-­ the­type­and­hardness­of­the­ma-
terial­to­be­treated;
-­ the­type­and­length­of­the­screws­
used.
Motor unit with
multisander
attachment PKGA2
­ (optionally­available)
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Steps­1­-­19
Step­
­ Wear­a­protective­mask­during­
grinding­work.
Attaching/removing­sanding­
sheet
The­sanding­plate­(21)­is­fitted­with­Velcro­for
rapid­attachment­of­the­sanding­sheet.­
Attaching sanding sheet
1.­ Press­the­sanding­sheet­(23)­evenly­onto­
the­sanding­plate­(21).­Ensure­that­the­
holes­in­the­sanding­sheet­are­placed­
above­the­openings­in­the­sanding­plate.
Removing sanding sheet
2.­ Simply­pull­the­sanding­sheet­(23)­off­
the­sanding­plate­(21).
Connecting­dust­extraction
You­can­reduce­dust­production­during­sand-
ing­by­attaching­a­dust­extraction­system.­
1.­ Push­the­adaptor­(24)­into­the­opening­
on­the­multi-sander­attachment­(22)­as­
far­as­the­stop.
2.­ Connect­a­dust­extractor­suction­hose­
to­the­adaptor­(24).
­ Make­sure­that­the­dust­extraction­system­
is suitable for the material to be cut. This
information­can­be­found­in­the­opera-
ting­instructions­of­the­external­device.
­ If­necessary,­you­can­connect­the­suc-
tion hose of a vacuum cleaner with-
out­reducer­(25)­to­the­adapter­(24).
Sanding
•­ Use­a­dust­extraction­system­when­sand-
ing­with­the­multi-sander­attachment.
•­ Move­the­appliance­against­the­work-
piece­once­it­is­switched­on.
•­ Clean­the­sanding­plate­before­you­at-
tach a sanding sheet.
GB MT
39