Parkside PKGA 20-Li C2 Traduccion Del Manual De Instrucciones Originale página 40

GB MT
•­ Only­work­with­sanding­sheets­in­per-
fect condition to achieve good sanding
results.
•­ Work­using­low­and­even­pressure.­
This­protects­the­appliance­and­the­
sanding sheet.
• Do not use the same sanding sheet to
sand­different­materials­(e.g.­metal­
and­then­wood).
Selection of sanding sheet
Grain size P Application
for­pre-sanding­rough­wood­
P 60
surfaces
P­80­/­120 for­plain­sanding
for­fine­sanding­of­primed­
P 240
and­painted­surfaces
Motor unit
with sabre saw
attachment PKGA3
Installing/changing­the­blade
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear gloves when handling the
sawblade.­In­this­way,­you­avoid­
injury from cuts.
Caution, risk of Injury!
-­ Do­not­use­any­blunt­or­bent­
blades or blades which are
damaged in any other way.
-­ Always­insert­a­suitable­saw-
blade.
40
­ An­overview­of­appropriate­blades­
can­be­found­in­"Spare­Parts/Ac-
cessories".
Installing the blade:
1.­ Push­the­lever­(18)­for­sawblade­un-
locking­downwards­as­far­as­the­stop­
and­keep­it­held­down.­Push the saw-
blade­shaft­(19/20)­into­the­sawblade­
mounting slot.
2.­ To­unlock,­release­the­lever­(18),­it­will­
return­to­the­initial­position.
3.­ Check­that­the­sawblade­is­secure­by­
pulling­on­it.
Removing the sawblade:
4.­ Press­the­lever­(18)­for­sawblade­un-
locking­downwards­as­far­as­the­stop­
and­then­pull­the­sawblade­out­of­the­
sawblade mounting.
­ For­certain­work,­the­sawblade­
can also be inserted after turning
through­180°.
Operating­the­sabre­saw
1.­ Before­switching­the­appliance­on,­ensure­
it­is­not­in­contact­with­the­workpiece.
2.­ Turn­the­appliance­on.­
­ By­using­the­on/off­switch­(10)­you­can­
progressively­control­the­stroke­rate.­
Gentle pressure:­low­stroke­rate.
Greater pressure: higher­stroke­rate.
­ The­on/off­switch­cannot­be­locked.
3.­ Place­the­footplate­(17)­on­the­work-
piece.
4.­ Cut­with­a­uniform­forward­motion.­
5.­ After­completion­of­the­work,­first­
switch off the device and then remove
the blade from the saw cut.