Aiwa VX-S205U Instrucciones De Manejo página 8

Preparing the remote control
To prevent damage from leakage or explosion, follow
the descriptions below.
. Insert two supplied R03 (size AAA) batteries with the
0 and O marks correctly as illustrated.
. Do not mix old batteries with new ones or different
types of batteries.
. Do not throw the batteries into a fire, apply heat to
them or take them apart.
. Do not carry the batteries with keys or other metallic
objects.
Remove the batteries when they have no more power, or when
you do not use the remote control for a long period of time.
Point the remote control toward the REMOTE SENSOR.
u
The remote control may not operate when there is any
obstruction between the remote control and the REMOTE
SENSOR.
Strong ambient light sources such as a fluorescent lamp or
direct sunlight may cause unreliable operation.
Using a TV with the same type of infrared remote control
facing the same direction may cause incorrect operation.
. The maximum distance for effective control between the
remote control and the REMOTE SENSOR is 7 meters.
Although you can use the remote control within an angle of
up to 30 degrees in any direction from directly in front of the
REMOTE SENSOR, we recommend a narrower angle for
stable operation.
The remote control can control the CATV converters for the
CATV. To control CATV converters, set the manufacturer's
code number shown in the table on the next page.
1
2
POWER —
Number —
buttons
— TV VCRICATV
— PRESET
— CHANNEL
A/v
Set the TV VCR/CATV selector to CATV.
While holding PRESET, press the number
buttonsto set the code numberreferringto the
table on the next page.
Some manufacturers have more than one code number.
If the remote control does not operate with the CATV
after setting the code number, try another number.
POWER, CHANNEL /VV and the number buttons
on the remote control are activated.
Due to the variety of codes used by manufacturers, Al WA
cannot guarantee that the MBR remote control will operate
with every model of the brands listed.
The number buttons can be used only for channel selection,
but they may not function correctly with some CATV
converters.
7
ENGLISH