Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Official Cecotec Technical Support Service
immediately.
3. APPLIANCE ASSEMBLY
Front foot stabiliser installation.Fig. 4
1.
Align the main frame screw holes (B) with the front foot stabiliser screw holes (F). Install
the hex screws (S2), flat washers (S6) and spring washers (S7) and tighten the assembly
using the 5 mm Allen wrench (S10) provided.
2. Attach the pedal crossbar (G) to the main frame (B) and tighten the pre-installed screws
and nuts.
Pedal installation.Fig. 5
Attach the pedals (C) to the main frame (B) and tighten the hex screw (S1) using the spanner
(S11) provided.
Note
distinguish pedals between left (L) and right (R). Do not install them in the wrong position.
Seat cushion stabiliser installation.Fig. 6
1.
Align the screw holes of the slideway (I) with those of the rear foot stabiliser (E). Install the
hex screws (S4), flat washers (S8) and spring washers (S9) and tighten the assembly using
the 5 mm Allen key (S10) provided.
2. Install the seat cushion stabiliser (H) onto the slideway (I) in the right direction.
Seat cushion and slideway installation.Fig. 7
1.
Attach the slideway (I) to the main frame (B) in the right direction and tighten the assembly
with the hex screws (S3) and flat washers (S6) provided.
2. Attach the seat cushion (D) to the seat cushion stabiliser (H) and tighten with the hex
screws (S3), flat washers (S6) and spring washers (S7) provided.
LCD monitor installation.Fig. 8
1.
Insert two AAA batteries into the LCD monitor.
38
DRUMFIT ROWER 5500 REGATTA
Publicidad
