Publicidad
Idiomas disponibles
Idiomas disponibles
2. Install the monitor (A) onto the main frame (B).
3. Connect the connection cable of the rowing machine to the corresponding sockets of the
LCD monitor.
4. OPERATION
Fig. 9
1.
Reset key
2. Mode key
3. Set key
After powering on the LCD monitor, the full screen display lasts for 1 second, and the screen
enters the default SCAN mode.
SCAN Mode
-
In SCAN mode, the monitor displays the following cycles: SCAN+TMR, SCAN+SPM,
SCAN+DST, SCAN+CAL, SCAN+STROKES, SCAN+Total STROKES. The display will
automatically and alternately switch to the next content displayed every 5 seconds.
-
The RESET and SET functions will not be available.
-
Press the MODE key to exit the SCAN mode and select the desired display mode from the
following functions: SCAN, TMR, SPM, DST, CAL, STROKES and Total STROKES.
-
After turning on the monitor, the display enters the SCAN mode.
Indoor Rower Icon
The rowing machine icon is always displayed in the lower left corner of the screen.
STOP Icon
The monitor will display ''STOP'' when you stop rowing and the machine is not in use for 4
seconds, and will disappear when you start rowing again.
TMR Mode
-
It displays the rowing time.
-
Press the SET key to set the time values, ranging from 0:00 to 99:00. Each time you press
the key, the time increases by 1 minute. Once you have finished setting the target time,
press the MODE key to confirm and exit the setting mode.
-
If you do not perform any operation within 30 seconds, the display will exit the setting
mode and the current setting value will be maintained.
-
Press and hold the SET key for 3 seconds to continuously increase the numerical values.
Release the SET key and the numerical value will immediately stop increasing.
-
Press the RESET key to reset the TMR values to zero. Press and hold the RESET key to reset
and restart the TMR values.
ENGLISH
DRUMFIT ROWER 5500 REGATTA
39
Publicidad
