Migatronic SIGMA2 300 Compact Manual De Instrucciones página 25

Connection/disconnection of water cooling
(MIG/MAG)
The water cooling function will
protection of the watercooled torch. The water cooling
will automatically be activated when welding is started
and stops automatically 3 minutes after welding has
been completed.
Configuration:
The following possibilities will be displayed after a long
pressure (> 5 secs) on the
0 = Water cooling disconnected
1 = Water cooling connected (factory setting)
Turn the right control knob until the requested number
is displayed. Press on the key next to the right control
knob or the -key pad to accept the chosen
parameter.
When a MIG Manager
automatically control the water cooling function and
disable this configuration.
ensure
- key pad:
®
is connected, it will
25