Publicidad
Idiomas disponibles
Idiomas disponibles
LTV38 R..TS/..TAS
Notice
Many events in the operating environment may af-
fect the tightening process and shall require a vali-
dation of results. In compliance with applicable
standards and/or regulations, we hereby require
you to check the installed torque after any event
that can influence the tightening result. Examples
of such events include but are not limited to:
• initial installation of the tooling system
• change of part batch, bolt, screw batch, tool,
software, configuration or environment
• change of air- or electrical connections
• change in line ergonomics, process, quality
procedures or practices
• changing of operator
• any other change that influences the result of
the tightening process
The check should:
• Ensure that the joint conditions have not
changed due to events of influence.
• Be done after initial installation, maintenance
or repair of the equipment.
• Occur at least once per shift or at another suit-
able frequency.
Safety and operating
instructions
Safety instructions
Warning
Make sure you are familiar with the operating in-
structions before you use the machine.
Before making any adjustments (e.g. setting the
torque, changing bits) disconnect the machine
from the compressed air line.
The machine, together with any attachments and
accessories, must never be used for anything other
than the designed purpose.
Use power sockets only. For safe and economic
use - replace worn sockets.
Check that the power socket is properly fastened -
replace the square drive retainer when necessary.
Keep your fingers and loose articles (cloths, hair)
away from the outgoing shaft.
Do not use gloves.
© Atlas Copco Industrial Technique AB - 9836 1857 00
Hold the machine correctly and be aware of the re-
action force.
Never use the nutrunner without making sure that
the clutch releases. Be aware of fluctuations in air
pressure.
Check the direction of the rotation before using
the machine.
When working in close spaces without the use of a
torque reaction bar - there is a risk of injuries due
to squeezing.
The operators of a nutrunner with a torque reaction
bar should take particular care to avoid injuries due
to squeezing. Never put your hand on or close to
the torque reaction bar while the machine is be-
ing used.
When using a suspension yoke, check that it is in
good condition and correctly fastened.
Installation of vibrating tools
It is recommended that a minimum length of 300
mm of flexible hose for compressed air is inserted
between a vibrating tool and the quick-action cou-
pling.
General information
EC DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB,
S-105 23 STOCKHOLM, SWEDEN declare that
the product (with name, type and serial number,
see front page) is in conformity with the following
Directive(s):
2006/42/EC
Harmonised standards applied:
EN 792-6
Technical file available from:
Quality Manager, Atlas Copco Industrial Tech-
nique, Stockholm, Sweden
Stockholm, 1 July 2013
Tobias Hahn, Managing Director
Signature of issuer
Safety Information
3
Publicidad
