Playback; Basic Playback; Stop Playback - JVC GR-AXM77UM Manual De Instrucciones

38
EN
REW
STOP
LCD Monitor in Retracted Position
Battery pack remaining power indicator
Tape counter
Recording mode indicator
SP
M–0: 23 : 45
LCD monitor/
viewfinder
indications
Power Switch
PLAY/PAUSE
FF
Tape running
4
indicator
4

: Playback

3
: Fast-Forward/
Forward Search
2
: Rewind/Reverse
Search
6
: Still Playback
PLAYBACK
LOAD A CASSETTE
1
First open the LCD monitor to an angle of over 45
degrees. Press EJECT to open the cassette holder,
then insert the cassette with the label facing out.
Press PUSH to ensure the holder is closed and
locked.
SELECT MODE
2
Make sure the LCD monitor is fully open. Then set
the Power Switch to "PLAY". The power indicator
lights.
PLAY BACK
3
Press PLAY/PAUSE. The playback picture appears.

STOP PLAYBACK

4
Press STOP.
Rewind or Fast-forward the tape
Press REW to rewind, or FF to fast-forward the tape
during Stop mode.
NOTES:
The camcorder shuts off automatically after about 5
minutes in Stop mode. To turn on again, set the Power
Switch to "POWER OFF", then to "PLAY".
When the Power Switch is set to "PLAY" and the LCD
monitor is opened at an angle of 45 degrees or more,
the LCD monitor switches on and the viewfinder
switches off automatically to save power.
The playback picture can also be viewed in the
viewfinder (with the LCD monitor shut) or on a
connected TV ( pg. 42). Camcorder operation is the
same as described in this section.
You can also view the playback picture on the LCD
monitor with it flipped over and retracted.
LCD monitor/viewfinder indications:
• The battery pack remaining power indicator is
displayed for approximately 5 seconds on the LCD
monitor when the LCD monitor is turned on, and
then it disappears. However, the battery pack
remaining power indicator "
power is almost gone.
• During Stop, Fast-Forward or Rewind mode, none of
the indications are displayed in the viewfinder.

Basic Playback

" blinks when the