JVC GR-AXM77UM Manual De Instrucciones página 48

48
EN
PLAY/PAUSE
REW
REW
PLAY
IN/OUT
IN
1 0:00:25
2
3
4
5
6
7
8
COUNTER
TOTAL
IN
1 0:00:25
2 0:03:18
3 0:02:33
4 0:04:11
5
6
7
8
COUNTER
TOTAL
FF
STOP
RM-V700U
(optional)
FF
PAUSE
ON/OFF
CANCEL
OUT
--: -- : --
0:00:25
0:00:00
OUT
0:01:05
0:03:31
0:02:53
--: -- : --
0:04:11
0:01:13
USING REMOTE CONTROL UNIT
SELECT SCENES
ACCESS R.A. EDIT COUNTER
DISPLAY
1
Press PLAY/PAUSE, then press ON/OFF and the
counter display appears on the LCD monitor or in
the viewfinder, and the screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under "IN" on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
"OUT" on the display. The total time of the
registered scene(s) is displayed at the bottom of the
screen.
REGISTER ADDITIONAL SCENES
4
Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
NOTES:
There must be at least one second between an in-point
and its corresponding out-point.
To ensure correct operation, there should be at least 15
seconds between an out-point and the next in-point.
Blank portions of tape cannot be registered as in-points
or out-points.
If it takes more than 5 minutes to search for an in-point,
the VCR's Record-Pause mode is cancelled and editing
doesn't take place.
Pressing ON/OFF clears all in- and out-points from
memory.
Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
(cont.)