Metabo HPT C 12LDH Manual De Instrucciones página 12

English
2. Securing the workpiece
WARNING:
3. Installing the holders ... (Optional accessory)
Holder
Steel square
(optional
accessory)
6mm wing
Height adjustment
nut (optional
bolt 6mm (optional
accessory)
accessory)
Fig. 9
4. Stopper for precision cutting ... (Stopper and holder are optional accessory)
Workpiece
6mm wing bolt
(optional accessory)
5. Confi rmation for use of sub fence (A)
WARNING:
Left bevel angle cutting
Direct angle cutting
Fence (A)
6. Confi rmation for use of sub fence (B)
WARNING:
Left bevel angle
cutting
Sub fence (B)
12
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
The holders help keep longer workpieces stable and in place during
the cutting operation.
6mm wing bolt
(optional accessory)
(1) As indicated in Fig. 9, use a steel square for aligning the upper
(2) After adjustment, fi rmly tighten the wing nut and fasten the holder
Base surface
The stopper facilitates continuous precision cutting in lengths of 11" to
Stopper
17-3/4" (280mm to 450mm).
(optional accessory)
To install the stopper, attach it to the holder with the 6mm wing bolt as
shown in Fig. 10.
Holder
(optional accessory)
6mm wing nut (optional accessory)
Height adjustment bolt 6mm (optional accessory)
Fig. 10
In the case of right bevel cutting, turn the sub fence (A) clockwise. Unless it is turned
clockwise, the main body or saw blade may contact the sub fence (A), resulting in
an injury.
Right bevel
Turn
angle cutting
Sub Fence (A)
Fig. 11
In the case of left bevel cutting, turn the sub fence (B) counterclockwise. Unless it
is turned counterclockwise, the main body or saw blade may contact the sub fence
(B), resulting in an injury.
Turn Right bevel angle cutting
Direct angle cutting
Fence (B)
Fig. 12
edge of the holders with the base surface.
Loosen the 6mm wing nut. Turn a height adjustment bolt 6mm,
and adjust the height of the holder.
with the 6mm wing bolt (optional accessory). If the length of
Height Adjustment Bolt 6mm is insuffi cient, spread a thin plate
beneath. Make sure the end of Height Adjustment Bolt 6mm does
not protrude from the holder.
This power tool is equipped with a sub fence (A).
In the case of direct angle cutting and left bevel angle cutting,
use the sub fence (A). Then, you can realize stable cutting of the
material with a wide back face.
In the case of right bevel cutting, raise the sub fence (A) up as
illustrated in Fig. 11 and then turn it clockwise.
This power tool is equipped with a sub fence (B). In the case of
direct angle cutting and right bevel angle cutting, use the sub
fence (B). Then, you can realize stable cutting of the material with
a wide back face. In the case of left bevel cutting, raise the sub
fence (B) up as illustrated in Fig.12 and turn it counterclockwise.