Metabo HPT C 12LDH Manual De Instrucciones página 13

7. Confi rmation for use of sub fence (C)
WARNING:
In the case of left bevel angle cutting, remove the sub fence (C). If the sub fence (C)
is not removed, the sub fence (C) will contact the main unit or saw blade and result
in injury.
Sub fence (C)
Fence (B)
Fig. 13
Sub fence (C)
Fig. 14
8. Position adjustment of laser line
WARNING:
* Make sure before plugging the power plug into the receptacle that the main body
and the laser marker are turned off .
* Exercise utmost caution in handling a switch trigger for the position adjustment of
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
CAUTION:
* Laser radiation- Do not stare into beam.
* Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
* Do not dismantle it.
This power tool is equipped with a sub fence (C).
In the case of direct angle cutting and right bevel angle cutting, use the sub
fence (C).
Then, you can realize stable cutting of the material with a wide back face.
In the case of left bevel angle cutting, remove the sub fence (C) by sliding
to the side and removing from the top as shown in Fig. 13.
Loosen knob (B) then remove the sub fence (C) (Fig. 14)
Fence (B)
WARNING:
Knob (B)
To attach the sub fence (C), insert then securely
tighten knob (B). If knob (B) is loose, the sub fence
(C) may move during cutting and result in injury.
Fig. 15
Fig. 16
English
13