Metabo HPT C 12LDH Manual De Instrucciones página 20

English
Sub fence (C)
Miter angle scale
Fence
(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 32 (see Fig. 37; tilt the head to the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the upper surface (B in Fig. 31) contacts the fence as indicated Fig. 39.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 32 (see Fig. 38; tilt the head to the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the lower surface (A in Fig. 31) contacts the fence as in Fig. 40.
Bevel angle scale
Miter angle scale
20
Head
Bevel angle scale
Fence (A)
Base
Turntable
Fig. 33
Table on Base
Fig. 35
Head
Fence (A)
Base
Turntable
Fig. 37
Fig. 39
Head
Sub fence (C)
Bevel angle scale
Turntable
Miter angle scale
Fence (B)
Fig. 34
Fence
Table on Base
Fig. 36
Fig. 38
Fig. 40
Base