Metabo HPT C 12LDH Manual De Instrucciones página 15

NOTE:
Check and make sure on a periodic basis if the position of the laser line is in order. As regards
the checking method, draw a right-angle ink line on the workpiece with the height of about
1-1/2" (38mm) and the width of 3-1/2" (89mm), and check that the laser line is in line with the ink
line [The deviation between the ink line and the laser line should be less than the ink line width
(0.5mm)]. (Fig. 20)
9. DIGITAL DISPLAY PANEL (for C12LDH)
Miter angle window
(Displays arrows show angle and
direction that turntable is rotating.
Left is ←, Right is →.)
Miter angle reset button
Digital display switch
(for C12LDH)
(Also serves as laser
marker power switch.)
Laser marker switch
Fig. 22-a
CAUTION:
When operating the digital panel, have the motor head section at the top limit
position and the blade stopped.
Note: • Before starting to cut, align the main unit to the miter angle 0° and the bevel angle 0° and
hold down thier reset buttons for at least 0.2 second. If you press the digital display switch
to ON without aligning the main unit to 0°, then the fi gures appearing on the digital display
and the main unit angle will not match.
• The laser marker will not light up if the digital display switch is turned off . (only on C12LDH)
• Do not use the main unit near equipment that generates electrical noise such as generators.
Electrical noise might cause faulty readings or operation on the digital display.
CAUTION:
When operating the digital panel, have the motor head section at the top limit
position and the blade stopped.
Reset button
Side handle
Move the turntable left and
right with the side handle
loosened and set it to the
correct position.
Fig. 22-b
Bevel angle window
(Displays arrows showing motor head
bevel angle and bevel direction. Left is ←,
Right is →.)
Bevel angle reset button
Back light ON/OFF switch (Press and the switch illuminates.
Press again and the lighting turns off.)
Fig. 21
(1) Turning on the digital display switch shows 0° for both miter and bevel
angle, regardless of main unit angle.
(2) Align the main unit angle with the tilt angle (0°) and miter angle (0°)
and hold down their reset buttons for at least 0.2 second.
(3) Turning on the laser marker switch while the digital display switch is
on, lights up the laser marker. (On the C12FDH∙C12FDH(S), only the
laser marker switch.)
CAUTION:
If the fi gure shown on the miter angle digital display
is diff erent from the positive stop angle (for example,
45.0° → 45.5°, 31.6° → 32.0°) then the positive stop has
probably deviated slightly from its correct position. If
this happens, do as follows.
(1) Move the turntable left and right with the side
handle loosened, and set the turntable to the
correct position.
(2) If the fi gures on the display and positive stop still
do not match, then return the turntable to the 0°
position. Next move the turntable left and right with
the side handle loosened as shown in Fig. 22-b.
After setting it to the correct position 0°, press the
reset button again.
English
15