Metabo HPT C 12LDH Manual De Instrucciones página 19

8. Crown molding cutting procedures
Fig. 31 shows two common crown molding types having angles of (θ) 38° and 45°.
For the typical crown molding fi ttings, see Fig. 32.
Fig. 31
The table below shows the miter angle and the bevel angle settings that are ideal for the two crown molding
types.
NOTE:
For convenience, positive stops are provided for the miter setting (left and right 31.6°)
positions.
For miter cut setting
If the turntable has been set to either of the angles described, move the turntable adjusting side handle a little
to the right and left to stabilize the position and to properly align the miter angle scale and the tip of the indicator
before the operation starts.
For bevel cut setting
Move handle on bevel section to the left and check that the position is stable and that the bevel angle scale
and the tip of the indicator are properly aligned. Then tighten the clamp lever.
To process crown molding at
Type of
positions 1 and 4 in Fig. 32.
Crown
Miter Angle
Molding
Setting
right 35.3°
45° Type
( mark)
right 31.6°
38° Type
( mark)
(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 32 (see Fig. 33; tilt the head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the upper surface (A in Fig. 31) contacts the fence as indicated in Fig. 35.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 32 (see Fig. 34; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the lower surface (B in Fig. 31) contacts the fence as in Fig. 36.
CAUTION:
In the case of left bevel angle cutting, remove the sub fence (C) before operation.
(Fig. 33 and 34)
Ceiling
Wall
To process crown molding at
positions 2 and 3 in Fig. 32.
Bevel Angle Miter Angle
Setting Setting
left 30° left 35.3°
( mark) ( mark)
left 33.9° left 31.6°
( mark) ( mark)
Inside corner
Outside corner
Fig. 32
Bevel Angle
Setting
left 30°
( mark)
left 33.9°
( mark)
English
19