Publicidad
Idiomas disponibles
Idiomas disponibles
ESPAÑOL
-
Bakery function (B): In this mode the food processor will set the optimum speed for the
best results, you can set the temperature, heat power and time to your liking.
-
Smoothie-Maker function (C): In this mode the food processor will set the optimal speed
and temperature for the best results. The default setting is 2 minutes of program time, but
you can modify it to your liking if you wish.
-
Chopper function (D): In this mode the food processor will set the optimal speed and
temperature for the best results.
-
Auto-Cleaning function (E): In this mode the food processor will heat the water up to 70
degrees and then perform two cleaning cycles.
Warning
-
After a few minutes the food processor will go into standby mode. To start it again, press
the start button.
-
Once the setting has been confirmed, the Mambo food processor will take a few seconds
to start working. The same will happen when you pause or end a function: it will take a few
seconds before you can unlock the system and open the lid and/or remove the jar from
the robot.
Timer
-
The LCD display shows the time indicator (hours: minutes: seconds).
-
Press the timer button and the minute sign on the LCD will flash; turn the selector to set
the minutes. Press it again, the seconds signal on the LCD will flash, turn the selector to
set the seconds. Press it again, the time signal on the LCD flashes, turn the selector to set
the hours from 1 to 12h.
-
If you press the timer during the cooking process, the food processor will start the
countdown directly.
-
To start the timer function you must press and hold this icon for 5 seconds, by default the
time set is 30 minutes, you can modify it by pressing the timer icon again and using the
selector to set the desired time. Once the time has been selected, press the selector to
start the countdown.
-
At the end of the countdown the food processor will beep.
Speed
-
Press this button in standby mode or during the cooking process, the appliance will enter
the speed setting mode. The signal on the LCD display will flash, then the speed will be
adjustable. Turn the selector clockwise to select the desired speed or counterclockwise to
select one of the five preset functions.
-
The speed range is from level 1 to 10.
-
The preset functions range from letter A to E.
-
There is a speed transfer in the structure, so it is normal to hear a small noise before the
engine starts running and in the shift between speeds 5 and 6.
62
Publicidad
