cecotec MAMBO 11090 Manual De Instrucciones página 57

Blade assembly
- Once the accessory holder is installed and secured, place the blades in it and, pressing
down, rotate counterclockwise. Fig. 8
- To remove them, press and turn clockwise. The blades are very sharp, use extreme caution
when handling them.
Warnings
- Use a cloth to cover the blades unit before handling them to avoid injuries.
- Assemble the fixing bracket and the sealing ring properly to avoid food or liquids being
cooked from splattering.
Tip
Setting speed 1 may be helpful when removing the blades, until you are familiar with the
removal system.
Assembly of the MamboMix spoon
Remove the blades, attach the Mambomix in the same way as you attach the blades. It can
be used for kneading, or stirring and mixing without cutting the food. Do not use it for a speed
higher than 3, otherwise it will cause a high vibration in the food processor and may cause
hazards. Fig. 9
Warnings
It is possible that some food may get between the wall of the jar and the MamboMix spoon, if
this happens, the motor of the product will stop working as a method of protection. Use the
spatula to mix and remove stuck food so that the food processor can continue the cooking
process.
Assembly of the measuring cup
- The measuring cup is used as a cover accessory to avoid splashing and reduce heat loss
during cooking. In addition, it is marked with a scale of measurements in ml.
- To place it in the lid, make sure that the anchoring tabs fit correctly into the lid and turn
clockwise. Fig. 10
Warning
- Use the measuring cup and not any accessory or object to avoid splashing and reduce heat
loss of the jar.
- When cooking with temperature setting, place the measuring cup in the cover's gap
without locking it in place. This way, steam will be safely released.
Spatula
- The spatula is the only component that must be used to stir the food in the jar.
ESPAÑOL
MAMBO 11090 / 11090 HABANA
57