Publicidad
Idiomas disponibles
Idiomas disponibles
ESPAÑOL
7. TROUBLESHOOTING
Warning code
Description
A1 warning
Locking system. The jar or the lid are
A2 warning
The jar is
incorrectly
positioned
A3 warning
Content
exceeded.
A4 warning
The
temperature is
too high.
A5 warning
Motor
temperature is
too high.
A7 warning
The change in
speed could
not be done
successfully.
A8 warning
Wrong NTC
sensor reading.
66
Possible cause
not fixed properly.
The jar is not in its
correct position or
connection of the
temperature sensor
at the jar base is
damaged.
There is too much food
inside the jar.
There is no or very little
food in the jar and the
set temperature is too
high for too much time.
The food processor has
been running too long
with too much food.
Speed change between
low level (1-5) and
high level (6-10) was
blocked.
The temperature
sensor is not working
properly.
Possible solution
Re-assemble the jar and
lid, make sure all the parts
are assembled properly and
tightly and try operating it
again.
Re-assemble the jar and
make sure it is fixed properly.
Remove some food from
inside the jar or cut the food
to smaller pieces and restart
the food processor.
Add food in the jar.
Stop using the food processor
and allow it to cool down
before operating it again.
Remove the jar, turn the fixing
bracket manually and place
the jar again in place. Restart
de food processor.
Contact the official Technical
Support Service of Cecotec.
Publicidad
