Fiorenzato XGi Serie Manual Del Usuario página 37

Series
5.3 "Initial start-up" procedure
This is the procedure required to start the grinder-doser for the fi rst time.
At initial start-up, the grinder-doser is confi gured by default to operate with the enabled
system. With this procedure, the operator is guided to enter and/or confi rm the data
required to make the grinder-doser operational.
• Check that there is an adequate amount of
coffee to grind in the loading hopper. Open the
locking slide to feed the grinding blades.
• Power up the machine by turning the switch to
the "I" position and wait for the operator panel
to initialise.
• When the "Confi rm Start" screen appears, press
Language to select.
• On the "Language" page, select the required
language from those available, then press
"Language" to return to the previous page.
• Proceed with adjusting the degree of grinding
by turning the adjustment disk (see Part 5.5).
Alternately adjust the adjustment disk and the
coffee dispensing command until the required
grain size is reached. Then press down the
button until the progress bar is completely fi lled.
If necessary, you can continue grinding even
after the progress bar has been fi lled.
• When the required grain size has been reached,
press the "Next" function key to continue.
• Press "Confi rm Start" to switch to the "Change
Dose Weight" page.
• Set the weight in grams for the single dose.
• Set the weight in grams for the double dose.
• Press the "Next" button to continue.
• Wait a few seconds without touching the
appliance to allow the weighing system to detect
the tare weight.
• Wait for the "Dispense single dose" command to
appear on the display.
Fiorenzato | Series_00 Ed. 04/2022
EN
Language
CONFIRM START
Language
Italiano
English
Español
Deutsch
Adjust the grain size by rotating the adjustment disk
g Single dose g Double dose
Tare weight detection
Do not touch the
grinder-doser
19 / 49
EN
• Start dispensing a single dose of coffee by pulse
pressing the function key shown on the display.
The grinding of the single dose of coffee starts
and stops when the red progress bar is fi lled.
• Wait a few seconds without touching the
appliance to allow the weighing system to detect
the tare weight.
• Wait for the "Dispense double dose" command
to appear on the display.
• Start dispensing a double dose of coffee by pulse
pressing the function key shown on the display.
The grinding of the double dose of coffee starts
and stops when the red progress bar is fi lled.
• Wait a few seconds without touching the
appliance to allow the weighing system to detect
the tare weight.
• Wait for the "Initial start-up successfully
completed" message to appear on the display.
• Press the button to return to the HOME
page.
• You can now use the appliance in "WEIGHT"
dispensing mode.
20 / 49
Series
Dispense a single dose
Tare weight detection
Do not touch the
grinder-doser
Dispense a double dose
Tare weight detection
Do not touch the
grinder-doser
Initial start-up successfully completed!
Fiorenzato | Series_00 Ed. 04/2022