Fiorenzato XGi Serie Manual Del Usuario página 48

Series
• Loosen the fastening screw (Part 1) and pull out
the coffee discharge tube (Part 2) from its position.
• Wash the tube with warm water and a pH-neutral,
unscented, degreasing and cleaning agent
specifi cally for use in the food industry.
• Wipe dry with a soft cloth.
• Using a vacuum cleaner and a dry cloth, clean all
coffee powder residues from the discharge tube
housing.
• The exterior of the machine body must be
cleaned using soft cloths and products suitable
for use in the food industry.
ATTENTION! Do not
sponges and/or aggressive products that
may damage the external surfaces of the
machine.
ATTENTION! It is forbidden to use water or
steam jets to clean the machine body.
Fiorenzato | Series_00 Ed. 04/2022
EN
2
1
use abrasive
EN
• After cleaning, reassemble the machine, put the
discharge tube (Part 1) back into place (Part 2)
and secure it by tightening the screw (Part 3).
• Place the hopper (Part 4) and secure it with the
appropriate screw (Part 5).
• Close the hopper with its lid (Part 6).
The machine is ready to be used again after being fed
and fi lled with coffee beans.
6.1.2 Checking the power cable status
AT THE END OF EVERY SHIFT: check the power supply cable.
• Disconnect the cable from the power socket,
check visually and by touching that the protective
sleeve is intact, that the wires are not exposed
and that the plug is not damaged.
ATTENTION! If the power cable is damaged,
replace it with one of the same type.
41 / 49 42 / 49
Series
6
4
5
2
1
3
Fiorenzato | Series_00 Ed. 04/2022