Medela Swing Maxi Instrucciones De Uso página 18

Cleaning (cont.)
5.6 Cleaning the tubing
18
Since the tubing only conveys an air flow (it has no contact with milk), normally cleaning of the
tubing is not necessary.
Inspect the tubing. If you find condensation in the air tube, wash and dry it immediately
or replace the tubing. If you see breast milk inside the tubing or tubing connector do not
attempt to wash, clean or sterilize the tubing. Instead contact the manufacturer.
Supplies needed:
• Drinking-quality water
• Mild dish soap
Washing the tubing
Drying the tubing
• Do not use the device with wet tubing; doing so will damage it.
1. Shake out any water droplets.
2. Hang the tubing to air dry.
3. Make sure that the tubing is completely dry before using it.
i
Information
1. Turn the device off.
2. Remove the tubing from the pump unit.
3. Remove the tubing from the connector lid.
4. Rinse the tubing by pouring cool water into both short
tubing ends until it flows out of the long tubing end.
5. Wash the tubing in warm, soapy water.
6. Rinse the tubing with clear water.
NOTICE
Parts needed:
• Tubing