Tennant T1581 Manual De Instrucciones página 26

Emptying the dirty water tank
! ATTENTION: before carrying out the operations
apply the parking brake.
When cleaning operations have been completed, empty
the dirty water tank.
If the tank is full, the indicator lights up and the cleaning
functions of the machine will be inhibited; after a few sec-
onds, the vacuum motor also shuts down. At this point the
machine must be brought to a halt and the dirty water tank
emptied, following the instructions indicated
- Take the machine to the designated service area.
- Unhook the hose from the clip.
- Empty the tank by way of the drain hose: keep
the hose raised initially and remove the plug, then
lower the hose gently and position it over the drain
outlet.
- Rinse the tank with clean water.
-
the directions given in the section "Cleaning the
-
hose to the clip.
Emptying the solution tank
! ATTENTION: before carrying out the operations
apply the parking brake.
The detergent solution tank can be emptied by proceeding
as follows:
below:
.
Emptying the debris bin (Cylindrical Brush
Model)
! ATTENTION: before carrying out the operations
apply the parking brake.
To empty the debris bin on the roller head model, open
bottom of the bin clockwise, then pull bin directly out of the
machine. Empty the debris and wash the bin.
EN
- Take the machine to the designated service area.
- Unhook the hose from the clip.
- Empty the tank by way of the drain hose: keep
the hose raised initially and remove the plug, then
lower the hose gently and position it over the drain
outlet.
26