Publicidad
Idiomas disponibles
Idiomas disponibles
HANDLING AND INSTALLATION
Lifting and transporting the palletized
machine
! ATTENTION: during all lifting operations, make sure
tipping over or being accidentally dropped.
The machine must be loaded onto/unloaded from
vehicles in areas with adequate lighting.
The machine is packaged on a wooden pallet by the
Manufacturer. It must be loaded on to the transporting
vehicle using suitable equipment (see Directive 2006/42/
EEC and subsequent amendments and/or additions). At
destination, it must be unloaded using similar means.
The palletized body of the machine can be lifted only with
the aid of a fork lift truck. Handle with care to avoid impact
and ensure the machine is not overturned.
Inspection on delivery
When the carrier delivers the machine, check that the
packaging and the machine are both intact and undamaged.
If the machine is damaged, make sure the carrier is aware
of the damage and before accepting the goods, reserve the
right (in writing) to request compensation for the damage.
Unpacking
! DANGER: when unpacking the machine, the
operator must wear suitable Personal Protection
Equipment (gloves, eyewear, etc.) to limit the risk of
injury.
When unpacking the machine, proceed as follows:
-
Cut and remove the plastic straps using scissors
or nippers;
-
Remove the cardboard packaging;
-
Remove the bags placed inside the battery
compartment and check the contents: user manual;
warranty reply card; quick guide; instructions for
setting up the battery type on the machine; battery
bridges with terminals; 1 x connector for battery
charger; 2 x hex wrench;
-
Remove the metal brackets securing the front/
rear wheels and the machine chassis to the pallet
base.
-
Release the parking brake by pressing the lever
next to the pedal.
-
Before unpacking the machine, check that the
head assembly is raised.
-
the reversing direction. The machine must not be
lifted.
-
Remove the brushes from their packaging.
-
Clean the outside of the machine, taking care to
observe safety regulations.
Once the machine is clear of the packaging, proceed to
install the batteries (refer to section "Batteries: installation
and connection").
The various items of packaging can be kept, if so desired,
as these can be reused to protect the machine in the event
workshop.
If not retained, the packaging must be disposed of in
compliance with current regulations.
EN
13
Publicidad
