Tennant T1581 Manual De Instrucciones página 36

PROBLEMS
Machine not working
Head brushes not turning
Head assembly not lowering/working
Side brushes not turning (roller head model)
The machine does not clean uniformly
Vacuum motor not working
The machine does not move
The batteries do not provide the normal working time
TROUBLESHOOTING
CAUSES
The batteries are disconnected
Fuse tripped
Ignition key not engaged
Emergency button pressed
The dirty water tank is full
Motor fuse tripped
Damaged motor
The dirty water tank is full
Actuator fuse tripped
Actuator damaged
Brushes raised
Motor fuse tripped
Damaged motor
The brush or disks are worn
Damaged solenoid valve
Dirty solenoid valve
Detergent solution tank empty
The hose delivering detergent to the brush is blocked
Pump fuse tripped
Pump damaged
Damaged solenoid valve
Dirty solenoid valve
The dirty water tank is full
Vacuum motor fuse tripped
Damaged motor
Squeegee blocked or damaged
The dirty water tank sensor has been activated or is blocked by
dirt, or is faulty
Blockage in the vacuum hose
The vacuum hose is not connected to the squeegee or is
damaged
Actuator fuse tripped
Actuator damaged
Damaged motor
Accelerator pedal pressed too quickly
The battery poles and charging terminals are dirty and oxidised
The electrolyte has evaporated and is not covering the plates
completely
The battery charger does not work or is not suitable
EN
SOLUTIONS
Connect the batteries to the machine
Recharge the batteries
Reset the fuse
Turn the key
Release the emergency button
Empty the dirty water tank
Reset the fuse
Recharge the batteries
Contact Customer Service
Recharge the batteries
Empty the dirty water tank
Reset the fuse
Contact Customer Service
Lower the side brushes
Reset the fuse
Contact Customer Service
Replace
Contact Customer Service
Contact Customer Service
Top up
Unblock
Open the tap
Reset the fuse
Contact Customer Service
Contact Customer Service
Contact Customer Service
Empty the dirty water tank
Reset the fuse
Recharge the batteries
Contact Customer Service
Replace the blades
Check
Empty the dirty water tank, check the sensor.
Check
Check
Reset the fuse
Contact Customer Service
Recharge the batteries
Contact Customer Service
When starting, press the accelerator pedal slowly
Clean and grease the poles and terminals, charge the batteries
Top up all elements with distilled water so that all plates are
covered, then recharge the battery.
Check
36