Publicidad
Idiomas disponibles
Idiomas disponibles
Choosing the battery charger
! ATTENTION: check that the battery charger is
compatible with the batteries being charged.
Tubular lead-acid (WET) batteries: an electronic battery
charger is recommended, but consult the manufacturer
of the external battery charger.
for the type of battery.
Preparing the battery charger
! ATTENTION: this procedure must be carried out
only by an authorized technician.
When using a battery charger not provided with the
the machine equipment package.
The connector supplied for the external battery charger is
suitable for cables with maximum cross-section 16 mm2
-
Remove around 13 mm of the protective sheath
from the red and black conductors of the battery
charger cable;
-
Attach the ends to the contacts of the connector
and squeeze forcibly with suitable crimping pliers;
-
Make certain the polarity is correct (red + black –)
when attaching the wires to the connector.
Battery charger settings
! ATTENTION: where machines are shipped without
batteries, the machine is factory set for WET batteries
Make certain that the battery charger is correctly set
up, according to the type of batteries installed.
Failure to observe these instructions could result
in damage to the battery. Depending on the type of
battery selected (WET or GEL - AGM), the battery
parameters of the machine MUST be adjusted
directions.
Fitting the squeegee
! ATTENTION: before carrying out the operations
apply the parking brake.
-
Loosen the two knobs.
-
Locate the two threaded pins in the slots on the
support.
-
Connect the vacuum hose to the squeegee,
bending it to the position as illustrated.
-
Tighten the two knobs.
The position of the squeegee is factory-set. Should the
squeegee blade require adjustment, refer to the section
"Squeegee adjustment".
Squeegee adjustment
! ATTENTION: before carrying out the operations
apply the parking brake.
drying. With time, and the constant wiping action, the edge
a new blade is required. The state of wear should be
checked frequently.
To ensure faultless drying, the squeegee must be adjusted
as illustrated, in such a way that the edge of the rear blade
at all points along its length.
EN
17
Publicidad
