Publicidad
Idiomas disponibles
Idiomas disponibles
EN
48
Cleaning the induction hob
•
Do not use steam cleaners.
•
Before cleaning, make sure the cooking zones are switched off and that the
residual heat indicator ("H") is not displayed.
•
Do not use abrasive sponges or scouring pads. Their use could eventually ruin
the glass.
•
After each use, clean the hob (when it is cool) to remove any deposits and
stains due to food residuals.
•
Sugar or foods with a high sugar content damage the hob and must be
immediately removed.
•
Salt, sugar and sand could scratch the glass surface.
•
Use a soft cloth, absorbent kitchen paper or a specifi c hob cleaner (follow the
Manufacturer's instructions).
Troubleshooting for the induction hob
•
Read and follow the instructions given in the section "Instructions for use".
•
Check that the electricity supply has not been shut off .
•
Dry the hob thoroughly after cleaning it.
•
If, when the hob is switched on, alphanumeric codes appear on the display,
consult the following table for instructions.
•
If the hob cannot be switched off after using it, disconnect it from the power
supply.
Error
Possible Cause
code
No Pan or did not detect
the pan.
The display board
E0
cannot receive the signal
from the power board.
The display board
EA
cannot receive the signal
from the power board.
E1
High voltage
E2
Low voltage
E3-E4
Abnormal temperature.
F3-F5
NTC short or open
F9-FA
Remedy
Put on the pan
Check the connection between the
display board and the power board, if
not , replace the power board.
Check the connection between the
display board and the power board, if
not , replace the power board.
Please inspect whether power supply is
normal. Power on after the power supply
is normal.
Please inspect whether power supply is
normal. Power on after the power supply
is normal.
Please inspect the pot. Please restart
after the hotplate cools down.
Call the after-sales service and specify
the error code.
Publicidad
