Klarstein MULTICHEF 4 Manual Del Usuario página 58

EN
58
Gas connection for gas hob
The gas hob should be connected to the gas-supply by a registered installer.
During installation it is essential to fit an approved gas tap to isolate the supply
from the hob for the convenience of any subsequent removal or servicing. Connect
the hob to the gas mains or liquid gas, it must be carried out according to the
prescribed regulation in force, and only after it is ascertained that it is adaptable
to the type of gas to be used. If not, follow the instructions indicated in the
paragraph headed "Adaptation to different gas types". In the case of connection to
liquid gas by tank, use pressure regulators that conform to the regulation in force.
Important: For safety, for the correct regulation of gas use and long life of the hob,
ensure that the gas pressure conforms to the indications given in table 1 "Burners
and Nozzle Specifications".
Connection to non-flexible tube
• Connection to the gas source must be done in such a way as to not create any
stress points at any part of the gas hob.
• The hob is fitted with an adjustable "L" shape connector and a gasket to the
gas supply.
• The connector should be dismounted and the gasket must be replaced.
• The feeding connector of the gas to the hob is threaded 1/2 gas cylinder.
Connection to flexible steel tube
The gas feed connector to the hob is threaded, 1/2" connector for round gas pipe.
Only use pipes and sealing gaskets that conform to the standards currently in
force. The maximum length of the flexible pipes must not exceed 2000 mm. Once
the connection has been made, ensure that the flexible metal tube does not touch
any moving parts and not be crushed.
Check the seal
Once the hob was installed, make sure all the connections are properly sealed, use
a soapy water to test, never use flame.
Electrical connection
The hob fitted with a tripolar electrical supply cord which are designed to be used
alternating current .According to the indications on the rating plate located under
the hob. The earthing wire can be identified by its yellow-green colour.
In the case of installation over a built-in electric oven, the electrical connections for
the hob and oven should be independent, not only for safe purpose, but also be
convenient to remove them in the future.
Electrical connection for gas hob
Fit the supply cord with a standard plug for the demand rate indicated on the