Klarstein MULTICHEF 4 Manual Del Usuario página 53

TROUBLESHOOTING
Gas burner
Problem
The burner cannot be lighted or the
flame is not uniform around the
burner.
The flame does not keep lighting to
the burner with thermocouple
The flame goes out while turning knob
to "Low" setting.
The cookware is not stable.
Induction burner
Problem
The cooking zones have become
soiled.
The residual heat indicator cannot
work.
Check to make sure that:
• The gas holes on the burner are not
clogged;
• All of the movable parts of burners
are fixed correctly;
• There is no air flow around the
cooking surface
• You press the knob all the way;
• You keep pressing the knob
for enough time to activate the
thermocouple.
• The gas holes are not clogged
in the area corresponding to the
thermocouple.
• The gas holes are not clogged.
• There is no air flow around the
cooking surface.
• The minimum has been adjusted
correctly (see the section entitled
"Minimum Regulation").
• The bottom of the cookware is
perfectly flat.
• The cookware is centred correctly
on the burner.
• The support grids have not been
inverted.
Check to make sure that:
This may be caused by burnt on
remnants of food. This will not
affect the working of the appliance.
However, you should make sure that
the cleaning instructions are being
followed regularly.
If the cooking zone does appear to be
hotter than 60 ℃ and the residual heat
indicator has not come on, contact a
qualified specialist for inspection and
repair.
EN
53