Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded (earthed) outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
A 220–240 V, 60 Hz, fused electrical supply is required.
■
A time-delay 10–16 A fuse or circuit breaker is
recommended.
This washer is equipped with a power supply cord having
■
a 3 prong earthed plug.
To minimize possible shock hazard, the cord must be
■
plugged into a mating, 3 prong, earthing-type outlet, earthed
in accordance with local codes and ordinances. If a mating
outlet is not available, it is the personal responsibility and
obligation of the customer to have the properly earthed
outlet installed by a qualified electrician.
If codes permit and a separate ground wire is used, it is
■
recommended that a qualified electrician determine that
the earth path is adequate.
If the supply cord is damaged, it must be replaced by
■
the manufacturer, its service agent, or a qualified person
to avoid a hazard.
Do not earth to a gas pipe.
■
Check with a qualified electrician if you are not sure
■
the washer is properly earthed.
Do not have a fuse in the neutral or earth circuit.
■
Philippines: Outlet must comply with Philippine National
■
Standard PNS 1572:1997 Annex A, 250 V, 10/15 A, 2-pole,
3-wire, grounding receptacle.
Only a Maytag service person, qualified electrician, or
■
similarly qualified person shall replace a power cord or
perform service on the electrical power supply in accordance
with these instructions and local codes and regulations.
This product is shipped with the AS/NZS 3112 power
■
cord installed. Additional power cords are supplied with
the product. Refer to the Power Cord Selection table to
determine the power cord required for your region, or if
needed, to order the appropriate approved Maytag power
supply cord.
6
EARTHING INSTRUCTIONS
This washer must be earthed. In the event of a malfunction
or breakdown, earthing will reduce the risk of electric
shock by providing a path of least resistance for electric
current. This washer requires a cord having an
equipment-earthing conductor and an earthing plug. The
plug must be plugged into an appropriate outlet that is
properly installed and earthed in accordance with all local
codes and ordinances.
WARNING:
Improper connection of the equipment-
earthing conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly earthed.
Do not modify the appliance power supply cord or plug – if it
will not fit the outlet, have a proper outlet installed by a
qualified electrician.
NOTE: Electrical safety standards: The manufacturer has
chosen compliance with IEC/EN.60335 standards as the most
appropriate for this product.
Sound Pressure Level, LpA: 58 dB(A) (uncertainty,
■
kPa: +/-3.6 dB
Power Cord Replacement Instructions
The steps in this section shall only be performed by a Maytag
service person, qualified electrician, or similarly qualified person.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. The appliance shall be disconnected from the power
supply before servicing. Read all instructions before any
disassembly.
Publicidad
