Publicidad
Idiomas disponibles
Idiomas disponibles
10. While the internal connector is still accessible, perform an
Earthing Continuity Test:
A current of at least 10 A, derived from a source having a
no-load voltage not exceeding 12 V (AC or DC), is passed
between:
n The grounding pin or earthing contact of the plug, and
n The grounding conductor of the appliance side connector
(female);
The voltage drop is measured and the resistance is calculated
and shall not exceed 0.2 Ω.
If not found to be properly grounded, contact the
manufacturer. Do not connect to the power supply.
Appliance Side
Grounding
Conductor
Ground Continuity
Test Location 1
11. Once ground continuity is confirmed, rotate the fully
assembled strain relief bracket and insert it into the opening
in the back panel with the connector side facing inward.
The installer shall ensure:
a) That the screw bore is aligned with the back panel screw
orifice.
b) The lip of the strain relief bracket is on the external side of
the metal back panel.
Screw
Bore
12. Insert the retaining screw from step 1 and secure the cord set
to the back panel. The cord assembly shall not be able to be
pushed inward, pulled outward, or twisted in any fashion that
puts stress on the internal conductors. If not secured, revisit
sections 7-11 and ensure proper installation.
8
IEC Plug
IEC Plug Type CEE 7/7
Type I
Type F&E Compatible
(Australia)
Plug
Grounding
Pin/Conductor
IEC Plug
Type G
Ground Continuity
Test Location 2
Strain Relief
Bracket Lip
INSTALLATION INSTRUCTIONS
Remove Transport System
Maximum packed weight:
PD model: 115 kg (253.53 lbs)
PR model: 111 kg (244.71 lbs)
Maximum unpacked weight:
PD model: 111 kg (244.71 lbs)
PR model: 107 kg (235.89 lbs)
IMPORTANT: Position the washer so that the rear of the washer
is within approximately 900 mm (3 ft) of its final location.
There are 4 shipping bolts in the rear panel of the washer that
support the suspension system during transportation.
1. Keep the washer in the upright position while removing the
shipping bolts.
Shipping bolt
Shipping bolt with plastic spacer
2. Using a 13 mm (1/2") wrench, loosen each of the bolts.
Publicidad
