Stiga AM 98 Li 48 V1 Manual De Instrucciones página 262

Current absorption indicator
The indicator fig. 9.Z. indicates
the current absorption level of the
battery by the machine.
NOTE
To increase battery life, adjust the
cutting height and forward speed of
the machine so that the absorption
of the battery is kept in the green
area of the indicator.
6.9 BLUETOOTH FUNCTION
The Bluetooth function, allows direct wireless
connection between the machine and a device at
a short distance.
The device must have the appropriate app
for data exchange installed, which can be
downloaded via the QRCode (fig.10), whose
instructions for use are provided separately.
The Bluetooth connection is activated
automatically when the machine is
started and the connection with the
device is confirmed when the icon is lit (fig. 9.D).
Check that the connection between the app and
the device is enabled.
7. USING THE MACHINE
CAUTION
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions to
avoid serious risks or hazards.
7.1 PRELIMINARY PROCEDURES
Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
7.1.1 Checking the battery
Before using the machine for the first time after
purchase, always fully charge the battery.
Before each use, check the charge status of the
battery (par. 8.2.2).
7.1.2 Seat adjustment
To change the seat position move the lever
(fig.11.A) upwards, and allow it to slide along the
guides until it reaches the desired position.
Make sure the seat remains firmly locked in place
and the lever returns to its original position.
The machine cannot be started without the
operator in the seat. (see 7.2.2).
7.1.3 Tyre pressure
Having the right tyre pressure is the main
condition for ensuring that the cutting-means
assembly is horizontal and mows evenly.
1. Unscrew the valve caps.
2. Connect a compressed air line with a gauge
to the valves (fig. 12)
3. Adjust the pressure according to the values
indicated in the "Technical Data" chart.
7.1.4 Preparing the machine before
starting work
NOTE
This machine can be used to mow lawns in a
number of different ways; before starting work,
prepare the machine based on how the lawn is to
be mowed.
a. Set up for cutting and
grass on the ground (only for models with
side discharge)(only for models of type
"I" and "II"):
spring of the deflector (fig. 5.A) and the safety
lever (fig. 5.B and 6.B) are working properly,
keeping it firmly in the lowered position.
b. Set up for grass cutting and shredding
(only for models of type "I" and "II"): If
the user prefers to cut the grass, shred it
finely and leave it deposited on the lawn,
a "mulching kit is available upon request
(par. 16.1) which must be fitted as indicated in
the relevant instructions.
7.1.5 Positioning the anti-scalp wheels
(only for models type "I" and "II")
The anti-chipping wheels are used to reduce
the risk of tearing up sections of lawn, which
can occur when the edge of the cutting-means
assembly drags over irregular ground.
Position the wheels as indicated (par. 8.3).
7.2 SAFETY CHECKS
Run the following safety checks and check that
the results correspond to those outlined on the
tables.
EN - 16
side discharge of
Always ensure that the inner