Stiga AM 98 Li 48 V1 Manual De Instrucciones página 258

used in these conditions the warranty will be
invalidated and the manufacturer will not be held
liable for any problems.
Do not open the cap of the USB port in rainy or
dusty areas.
The manufacturer declines all liability for damage
caused to the accessory connected to the USB
port or for any loss of data during its use.
6.7 BATTERY CHARGING SOCKET
The charging socket
flap (fig. 8.G) at the rear of the machine.
To charge the battery follow the instructions
provided in par. 8.2.2.
6.8 PUSH-BUTTON PANEL
The machine is equipped with a push-button
panel (fig.8.H) whose layout differs depending on
the model (fig.9) and includes the controls and
indicator lights described below.
6.8.1 Push-button (type "I") fig. 9
Machine START push-button
With the key inserted all the way,
this push-button (fig. 9.A) turns
the machine on and enables all
functions. A beep is heard when the
machine is turned on.
NOTE
If all safety conditions are met, the
"Ready" icon (fig. 9.M) is lit and the
machine is ready to be used
(see chapter 7.4).
Battery LED
The LEDs (fig. 9.B) normally
indicate the battery charge level
of the machine, but specific
combinations of their illuminated
status provide some information
regarding machine malfunctions
(see chap. 15).
HEADLIGHT switch on button
By pressing the push-button
fig. 9.C the headlights are switched
on/off.
"Bluetooth" icon
The icon fig. 9.D is lit when the
machine and the data exchange
device are connected.
is accessible by lifting the
Cutting means engage/
disengage push-button
By pressing the push-button
fig. 9.E the cutting means are
engaged/disengaged.
• The cutting means become
• When disengaged, a brake is
NOTE
If the cutting means are engaged
without respecting the safety
conditions, the machine will shut
down or cannot be turned on
(see par. 7.2.2).
Caution Icon
The icon fig. 9.F, if lit, indicates
failure to comply with safety
conditions or a possible malfunction
of the machine (see chap. 15).
Emergency push-button icon
The icon (fig. 9.G) is lit when the
emergency push-button is enabled
(see par. 6.2).
Operator on board icon
The icon (fig. 9.H) is lit when the
operator is not sat on the seat
(see par. 7.2.2).
Transmission engagement /
disengagement lever icon
The icon (fig. 9.l) is lit up when the
transmission is not engaged
(see par. 6.3 and chap. 15).
Controller and/or motor over-
heating icon
The icon (fig. 9.L) indicates
overheating of the electrical
components. See chap.15.
"Ready" icon
The icon (fig. 9.M) is lit with the key
fully inserted and after pressing the
start button.
"STANDARD/PERFORMANCE"
gear mode push-button
When started, the machine
automatically runs in "STANDARD"
mode. The push-button
(fig. 9.R) switches between
"PERFORMANCE" and
"STANDARD" gear.
EN - 12
operational after a few seconds
from being engaged.
enabled which stops the cutting
devices from rotating within a few
seconds.