Dovre 101CBS Instrucciones De Instalacion Y Uso página 33

Installation
Preparation
Please check the appliance for damage caused
during transport or any damage or defects immedi-
ately after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
but notify the supplier.
Remove the detachable parts (vermiculite interior
plates, baffle plate) from the appliance before you
install it.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the
correct place later on.
Removing inner plates
Vermiculite inner plates are light and tend to
be ochrous in colour on delivery. They
insulate the combustion chamber to boost
combustion. Cast iron inner plates protect the
combustion chamber and dissipate heat to the
surroundings.
Follow the instructions below to remove the inner
plates; see following figures.
1
2
Subject to change because of technical improvements
1. Pull forward the inner plate (4) at the bottom and
2. Slide the inner plate at the top of the appliance
3. Push the plate upwards so that you can tip it
4. Lower the plate to the bottom in the space.
5. Remove the plate from the appliance using the
6. Tilt the inner plate (2) from both sides and
7. Remove the rear plate (3) from the appliance
4
3
09-20020-255
remove it via the door opening.
forwards (1).
diagonally.
door.
remove the plate from the appliance using the
door.
using the door.
D OVRE
9