Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the legs
Fit the legs to the appliance; see the following figure.
1. Tip the stove from the side.
2. Fit the four legs (1) on the studs (4) using the
washers (2) and the M8 nuts (3) that are found on
the bottom plate.
3. Set the appliance upright on the mounted legs.
Support the appliance when placing it upright
so that not all the weight is not on the legs.
Mounting the handle
Use the supplied M6x20 screw to attach the handle
to the mounting hole.
Preparing the connection to
the flue
When connecting the appliance to the chimney you
have the choice of connecting via either the side, the
rear or the upper side. See the paragraphs
"Connecting on the side or to the rear" and
"Connecting to the upper side". It is also possible to
make a connection via the attachment 5T that can be
ordered separately; see the paragraph "Connecting
via the attachment".
D OVRE
10
A special connection collar is required to connect
to the upper side of the appliance.
The appliance is not supplied with a flue gas
opening.
Sealant and materials supplied.
Connecting to the side or the rear
First of all, choose whether to connect the appliance
to the flue from the side or the upper side or the rear.
The appliance can only be connected in
position 1, 2, or 3; see following figure.
Make the flue gas opening in the appliance by
removing the connection cover. Use the equipment:
the tension piece, the washer, the nut and bolt; see
following figure.
Only the rear covers of the side walls can be
used as a flue gas opening.
Subject to change because of technical improvements
Publicidad
