Safety Instructions; Safety Warnings In The Manual; Safety Warnings In The Product; Preliminary Recommendations - WEG CF W100 Serie Manual Del Usuario

Safety Instructions

1 SAFETY INSTRUCTIONS
This manual provides information for the proper installation and operation of the CFW100 frequency inverter.
It has been written to be used by qualified personnel with suitable training or technical qualification for operating
this type of equipment. The personnel shall follow all the safety instructions described in this manual defined
by the local regulations. Failure to comply with the safety instructions may result in death, serious injury, and/or
equipment damage.

1.1 SAFETY WARNINGS IN THE MANUAL

The following safety notices are used in the manual:
DANGER!
The procedures recommended in this warning have the purpose of protecting the user against death,
serious injuries and considerable material damage.
ATTENTION!
The procedures recommended in this warning have the purpose of avoiding material damage.
NOTE!
The information mentioned in this warning is important for the proper understanding and good
operation of the product.

1.2 SAFETY WARNINGS IN THE PRODUCT

The following symbols are attached to the product, serving as safety notices:
High voltages are present.
Components sensitive to electrostatic discharge.
Do not touch them.
Mandatory connection to the protective ground (PE).
Connection of the shield to the ground.

1.3 PRELIMINARY RECOMMENDATIONS

DANGER!
Always disconnect the main power supply before touching any electrical component associated to
the inverter. Several components can remain charged with high voltages or remain in movement (fans)
even after the AC power is disconnected or switched off. Wait at least ten minutes after turning off
the input power for the complete discharge of the power capacitors. Always connect the grounding
point of the inverter to the protection earth (PE).
6 | CFW100 G2