MIRKA PS 1519 Instrucciones De Manejo página 51

Use
Setting the speed
The speed can be preset via the thumb-wheel (3) and is infinitely variable
Switching On and Off
When polishing or sanding, always place the tool on the work surface before starting the tool
The machine must not be allowed to draw in additional dust and shavings When switching the machine on
and off, keep it away from dust deposits After switching off the machine, only place it down when the motor has come
to a standstill
In continuous operation, the machine continues running if it is forced out of your hands Therefore, always
hold the machine with both hands using the handles provided, stand securely and concentrate
See Figure 1:
Switching on, speed: press the trigger switch (5) Press in the trigger switch to increase the rotational speed
Switching off: Release the trigger switch (5) to switch off
Continuous activation: With the trigger switch (5) pressed, push in the lock button (4) and release the trigger
Press and release the trigger (5) again to switch off
Cleaning
It is possible that particles deposit inside the power tool during operation This impairs the cooling of the power tool
Conductive build-up can impair the protective insulation of the power tool and cause electrical hazards
The power tool should be cleaned regularly, often and thoroughly through all front and rear air vents using a dust
extractor Prior to this operation, separate the power tool from the power source and wear protective goggles and a
dust mask
Troubleshooting
The machine does not start. The electronic signal indicator (see no. 3, Figure 1) flashes. The restart
protection is active If the mains plug is inserted with the machine switched on or if the power supply is restored
following an interruption, the machine does not start up Switch the machine off and on again
Accessories
Use only genuine Mirka accessories
Use only accessories which fulfil the requirements and specifications listed in these operating instructions
For a complete range of accessories, see www mirka com
Repairs
Repairs to electrical tools must ONLY be carried out by qualified electricians!
A defective mains cable must be replaced only with a special, original Mirka mains cable
Contact your local Mirka representative if you have Mirka power tools requiring repairs See www mirka com for
addresses
A list of spare parts can be found at: www mirka com
Mirka® Polisher PS 1519 • 230 V
en
51