Angelo Po 04WFAAV Manual De Uso E Instalación página 39

ADJUSTING TOP BURNER PRIMARY AIR (7KW)
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panels (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of 20
mm, and tighten the screw (D).
6 - Replace the control panels (B) and the knobs
(A) on completion of the operation.
ADJUSTING TOP BURNER PRIMARY AIR (10KW)
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panels (B).
4 - Remove the screw (D).
5 - Set the burner mount (E) at a distance of 20
mm, and tighten the screw (D).
6 - Replace the control panels (B) and the knobs
(A) on completion of the operation.
GREASING THE GAS TAP
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panels (B).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
7 - Coat the cone with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to remove the excess
grease.
9 - Replace the cone (F) and the cap (E).
10 - Replace the control panels (B) and the knobs
(A).
C
A C B
C
A C B
C
A C B
- 17 -
E
D
IDM-39610801500.tif
E
D
IDM-39610801600.tif
E F
D
IDM-39610801700.tif
English
IT
GB
DE
FR
ES