Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
NOTE: The connection must be made
by authorised, skilled personnel, in accor-
dance with the relevant legal requirements,
using appropriate and specifi ed materials.
The appliance is supplied with operating
voltage 230V/1N.
HAZARD: Before doing any work, cut
off the mains electricity supply.
Connect the appliance to the mains electricity
supply as follows.
If not already present, install a circuit-breaker
1)
(A) with overload cutout and diff erential
safety breaker close to the appliance.
Pull off the knob (B).
2)
12
ELECTRICAL CONNECTION
3)
4)
5)
care over the connection of the neutral and
earth wires; if they are not connected cor-
rectly, the burner does not light.
6)
HANDLING AND INSTALLATION
Undo the screws (C) and remove the control
panel (D).
Undo the screws (E) to remove the lid (F).
Connect the circuit-breaker (A) to the termi-
nal board (G) of the appliance as shown in
the diagram and in the electrical system dia-
gram at the back of the manual. Use a cable
with at least H05RN-F characteristics.
IMPORTANT: When connecting, take
Replace the lid (F) and the control panel (D)
on completion of the operation.
3329590_inst_GB_rev.2
Publicidad
