Publicidad
Idiomas disponibles
Idiomas disponibles
A and N.
B and N.
C and N.
FF and FN
The PowerNet P-600 version manufactured with a 4 wires external cable is
called "PowerNet P-600 4 wires ". The input for tension measurement signal
conductors
and equipment feeding are the same
The equipment feeding source is triphasic; this means that even having a
tension failure in one o two phases of the electrical network, the equipment will
continue to operate.
Condutors
A, B, C
A and N.
B and N.
C and N.
3.3.2. CURRENT CONNECTOR
The current sensors has an output in tension, increasing, this way, to worker
safety in the case of a broken current cable.
You should be careful in order to not connect into this input any signal other that
the ones determined by IMS.
Never try to connect sensors with output in current directly in this input, or try to
feed the equipment through it. The maximum tension supported by this conductor is
4. INSTALLING
The PowerNET P-600 should be attached to a panel or pole before been
connected to the electrical network. When executing any procedure of electrical
installing or servicing, always must be followed the technical standards defined by the
appropriate authority, and/or the actual international standards.
4.1. INSTALLING REQUIREMENTS
Be sure that the people installing the PowerNET P-600
have the appropriate qualification, cause it will be dealing with dangerous tensions.
PowerNET P-600
300Vca
300Vca
4 wires version (on request):
Conductors Maximum tension
between circuits
500Vca
300Vca
ATTENTION
3 Via.
ATTENTION
Installing and Operating Manual
Equipment feeding
.
Description
Tension measurement
and Equipment feeding
106
Publicidad
