Publicidad
Idiomas disponibles
Idiomas disponibles
To enter in the PowerNET P-600 configuration mode utilize the second function
key F0.
6. CONFIGURATION
To make any configuration through the keyboard or the ANALYZER
SOFTWARE the memory status must be in "stop" in the memory screen. Utilize the
second function key F0 to enter in the desired PowerNET P-600 CONFIGURATION.
6.1. KEYS FUNCTION DURING CONFIGURATION
This key is utilized to increase, enable or change the parameter status
according with the configuration is been used.
This key is utilized to decrease, disable or change the parameter status
according with the configuration is been used.
This key has the function of leave the configuration mode.
6.2. PT /CT, SENSORS, CONNECTION, ANEEL REQUIREMENTS AND
ELEMENTS
Press the key F0 to activate the second function, when the display shows an f
letter at the lower right corner press F1. When the screen below is showed:
TN
Programa TP/TC ? = Program PT /CT? <F1>
Mostrar Max&Min? = Show Max&Min <F4>
Press F1 to enter in this parameters configuration.
PT Primary: (Primary of the power transformer)
v Utilize the increase or decrease keys to adjust the desired value for this variable.
PowerNET P-600
These keys are utilized to go right or left in the measurement
blocks configuration to be registered in memory.
Installing and Operating Manual
114
Publicidad
