Sony UPX-DP10 Manual De Instrucciones página 85

Status Indications on the printer
The printer status is indicated by the POWER, PRINT,
PAPER, RIBBON, and ERROR lamps lighting or
flashing. If the printer is in an abnormal condition,
take whatever action is called for by the status
indicated by the lamps.
Lit Flashing Printer status and action
POWER — • The power is on.
PRINT — • Printing is in progress.
— PRINT • The printer is receiving image
PAPER — • The printer is out of paper.
t Load more paper in the paper
• There is too much accumulated
t Remove the accumulated
RIBBON — • The end of the ink ribbon has
t Install a new ink ribbon
• No ink ribbon cartridge has been
t Install an ink ribbon cartridge.
ERROR — • There is a paper jam inside the
t Remove the jammed paper.
• The ribbon cartridge cover is
t Close the cover.
• The bottom cover is open.
t Close the cover.
All lamps — • A problem has occurred that
t Contact your Sony dealer or
data.
supply/eject tray. (page 32)
ejected paper in the paper
supply/eject tray.
ejected paper from the paper
supply/eject tray.
been reached.
cartridge. (page 30)
installed.
(page 30)
printer.
(page 86)
open.
requires repair by service
personnel.
the nearest Sony service
facility.
Error messages on the LCD of the station
If a problem occurs, the POWER/BUSY lamp on the
station lights in red and an error message stating the
problem appears on the LCD of the station.
Message in Possible causes/Action
the station's LCD
CHECK RIBBON • The ink ribbon cartridge is defective.
t Replace the defective ink ribbon
cartridge with the new one.
• The ink ribbon cartridge that can not
be used with this printer has been
loaded.
t Load the appropriate ink ribbon
cartridge.
PAPER JAMMING • The paper has jammed inside the
printer.
t Remove the jammed paper.
(page 86)
SENSOR TROUBLE • Sensor trouble has occurred.
t The printer must not be operated
any further. Turn off the power
immediately and contact your
Sony service facility or your Sony
dealer.
END OF RIBBON • The ink ribbon has been exhausted.
t Replace the old one with a new
ink ribbon cartridge. (page 30)
(The ink ribbon cannot be reused.)
INSERT RIBBON • The ink ribbon cartridge is not
loaded.
t Load the ink ribbon cartridge.
(page 30)
SET PAPER • Paper has been exhausted.
t Load the paper. (page 32)
• The paper supply/eject tray is not
installed.
t Install the paper supply/eject tray.
(page 32)
INSERT RIBBON • The ink ribbon cartridge and paper
SET PAPER are not loaded.
t Load the ink ribbon cartridge and
paper. (pages 30 through 32)
REMOVE PRINTS • The maximum number of printouts
has accumulated on the paper
cover.
t Remove the printouts from the
paper cover.
REMOVE PAPER • The paper jams around the paper
tray as it is being fed into the ribbon
area.
t Remove the jammed paper.
(page 86)
CLOSE COVER • The top cover opens.
t Close the top cover.
85